This customer from the village of Worfield has a Travertine tiled floor in their kitchen/dining room which had a crack across four of the tiles. The dining room forms an extension to the original old building and as you can the crack had occurred along the front of the patio doorway. Potentially this could indicate an issue with the foundation as there was a definite difference in the height of the tiles on either side of the crack.
Repairing Cracked Travertine Tile
To repair the crack I cleaned the area, dried it and then filled the crack with a colour matching resin. When the resin was set I started to grind the tiles to bring them back to the same level and then finished by polishing.
Naturally I mentioned our cleaning and sealing service but as it turns out the customer had only recently cleaned and sealed the floor themselves and so I was only needed for the repair which I think you will agree has turned out rather well, certainly the customer was happy as they left the following feedback on my profile.
“Jozsef has done a brilliant job, would certainly recommend him .”
The photographs below probably don’t do this job justice but in summary recent high winds had dislodged tiles from the roof adjacent this conservatory at a house in Oldham causing them to smash through the glass roof and damage the Travertine Tiles on the floor below.
Cleaning, Filling and Polishing Travertine Tiles
The first job was to wash the floor down with Tile Doctor Pro-Clean to give it a general clean and remove any surface dirt and grit from the floor. Travertine is a very hard stone so to restore the finish it needs to be cut back and polished using of a set of diamond encrusted burnishing pads fitted to a rotary machine. You start with a coarse pad with a little water, then a medium pad, fine pad and finish with a very fine polishing pad, this takes some time but the effect it quite transforming, it does build up slurry on the floor so it all needs to be washed down again at the end. I use a wet vacuum to remove the liquids from the floor and this also gets the floor quite dry. I then filled the holes in the damaged tiles using resin cement that matched the colour of the Travertine.
Sealing and Buffing Travertine Tile
I let the floor dry fully overnight and came back the next day to seal the tiles checking first with a damp meter that the floor has dried. A sealer is highly recommended for natural stone as it protects the stone from staining and keeps it looking good for longer. For this floor I used coats of Tile Doctor Colour Grow which is a colour enhancing sealer that brings out the colours in natural stone, it’s also an impregnating sealer that soaks into the pores of the stone and preventing dirt becoming ingrained there. Once the sealer was dry it was buffed using a white buffing pad to make sure that I hadn’t left any residues from the seal.
The job took two days to complete and the customer was very happy with the final finish and the fact that you could not tell where the damage had been.