The owner of this home in Ascot had 75m2 of travertine tiles installed on the ground floor and around 10 tiles were damaged and needed replacement; this can be difficult as like most things tiles are created in batches and it can be tricky to find an exact match. Fortunately we managed to source a very close match and set about installing them.
Cleaning Travertine Tiles and Grout
To get the match as close as possible we then set about giving the whole floor a general clean using Tile Doctor Pro-Clean which is a multi-purpose cleaner, it was equally important to concentrate on the grout of the existing floor which needed to be clean to match the new grout of the new floor. Cleaning the floor also ensures any grit is removed from the tile surface prior to the next step which was to polish the floor using a set of Burnishing pads, this is important as grit could get trapped in the burnishing pads and scratch the floor. We washed the floor down with clean water using a wet vacuum to remove the water from the floor before moving onto the next step.
Polishing and Sealing Travertine Floor Tiles
We polished the floor using a set of 17” Burnishing pads fitted to our weighted polishing machine; the pads are diamond encrusted and you start with the coarser Red pad designed to remove sealers before moving on to the White, Yellow and finally Green polishing pad to achieve a high shine finish.
The last step was to seal the floor which we did using two coats of Tile Doctor Colour Grow which is colour intensifying sealer that enhancing the natural colours in the Travertine tile as well as providing on-going durable surface protection.
We polished and sealed the entire floor to ensure a consistent look; the customer was certainly happy and left the following comment.
“Overall a good job well done. Thank you.
Mr. Wilkinson, Ascot”